Personal Video Database

English => Support => Topic started by: deazo on December 03, 2009, 06:52:39 pm

Title: Is this possible?
Post by: deazo on December 03, 2009, 06:52:39 pm

 Hi, this is my second question for the day.
 When scanning folders for movie files, sometimes the tool makes a mistake, and even though the movie card already exists (without a file path), it proposes to "add a new movie".
 I know you can switch from "set file path/change file path" to "add a new movie", but can you do the reverse?

 I would like to switch the action from "add new movie" to "set file path", i would then choose the corresponding film card and point it to the file that was discovered by the scan.
 Is this possible?

Thanks again.

Title: Re: Is this possible?
Post by: nostra on December 04, 2009, 02:07:02 am

It is not possible, but it probably will be some time later.

Title: Re: Is this possible?
Post by: rick.ca on December 04, 2009, 02:53:36 am

Quote

...but it probably will be some time later.

I've been looking forward to that for some time now. ;)

Title: Re: Is this possible?
Post by: deazo on December 04, 2009, 04:42:09 pm

 OK I shall wait and pray then.